Master reboot crestronntouch panel4/25/2023 ![]() Firmware can be loaded to the TST‑902 via Crestron Toolbox™ software if the touch screen has been connected to a Wi‑Fi network. The TST‑902 firmware should always be updated to the latest version. Tap Connect to a different access point to return to the Connect to a Wi‑Fi Access Point: 1-2-3 screen. If the connection fails, a failure message is displayed. If the connection is successful, details for the Wi‑Fi connection are shown in the Wi‑Fi Setup screen. The touch screen attempts to connect to the WAP using the provided credentials. Tap Step 3 - Make this my Access Point to confirm the selection.Tap the Password text field to display an on-screen keyboard for entering the password for the WAP.The name and security type for the selected WAP are displayed in the settings on the right of the screen. Select a wireless access point (WAP) from the Step 1 - Select a WAP list.The Connect to a Wi‑Fi Access Point: 1-2-3 screen is displayed. Return to the Wi‑Fi Setup screen, and then tap Select a Wi‑Fi Access Point.Tap Apply Changes, and then tap Reboot to restart the touch screen with the new static IP address settings.Tap the back button to return to the Wi‑Fi Setup screen.Alternate Preferred DNS: Enter a static address for the secondary DNS.Preferred DNS: Enter a static address for the preferred DNS (Domain Name Server).Static Default Router: Enter a static address for the default gateway router.Static Subnet Mask: Enter a static subnet mask address.Static IP address: Enter a static IP address for the TST‑902.Tap the following fields to display on-screen keypads for inputting static IP addresses:.If a static IP address will be assigned to the TST‑902, select Set Static IP Address Settings to display the Wi‑Fi Setup - Static IPs screen.To connect the TST-902 to a Wi‑Fi network: The USB port is located under the battery cover and to the left of the battery. NOTE: If a Wi‑Fi connection is not configured, the USB port on the TST‑902 must be used to load user projects, perform certain configuration tasks, and update firmware. Advanced wireless capabilities such as streaming video, voice recognition, web browsing, and dynamic graphics are supported only by using both ER and Wi‑Fi communications together (dual‑mode). The TST‑902 supports an optional connection to a Wi‑Fi network. Once an "Acquire OK" message is displayed on the RF Setup screen, exit Acquire mode on the ER gateway as described in its documentation.An "Acquire in progress" message is displayed on the RF Setup screen, and the TST‑902 will be acquired by the ER gateway within two minutes. Tap Acquire to place the TST‑902 into Acquire mode.Access the TST‑902 setup screens as described in Access the Setup Screens.Place the ER gateway into Acquire mode as described in its documentation.To acquire the TST‑902 to a Crestron ER gateway: Then, enter in your master code (the default code is 1234). ![]() If you need to reset the date and time on your alarm, open up the keypad panel and enter 6. The TST‑902 will not work over Wi‑Fi® communications alone. Press 6, then enter the master code and press 1. NOTE: Every TST‑902 installation requires a Crestron ER wireless gateway to provide essential wireless capability to the touch screen.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |